3D Resin Wolf Man

The "box art" for this purchase on eBay. The kit itself didn't provide any instructions.

I purchased this kit from the same seller on eBay that I got the Stephen King statuette from that you can see elsewhere on this site. The quality of this resin print is at about the same as the King statue which isn't saying much although I didn't come across any unreacted resin areas as I did with the other kit. It is comprised of only eleven parts including the base and the size is comparable to the Aurora monster kits that came out in the mid sixties.

Assembly was simple with some extensive sanding work required on getting a good match between the larger body parts and a few of the placement keys had to be trimmed a bit. There were some resin support nubs here and there but those cleaned up with a sanding drum on my motor tool.

I didn't change the figures very much with the exception of adding a necklace to the female figure and adjusting her face a bit. The eyes were cast wide open which looked kinda creepy to me so I filled them a little with a couple layers of Elmer's glue to look like she had passed out and not staring blindly into space. Like I said, creepy.

I went with a typical color scheme for this type of kit which is a result of my low interest invested in it. I did like the scene in general with the Wolf Man holding a potential victim in his arms, a pose I have always favored, and hence the initial reason for my purchase. I have since discovered the 3D resin print files for this kit on the Goggle machine which cost significantly less than what I spent on eBay so I will keep this in mind should I decide to tackle this kit again. 4/8/22